TFTP Server Settings Configure Server Security L use UDP 69 port not only to receive TFTP requests, but also for files transmission. To activate this option, open the window TFTP Server Settings and check Enable firewall support on General tab.Īfter the window is closed, TFTP server wil It is the standard port number for TFTP requests. However, this is not common for most of routers and firewalls.Īt the same time, WinAgents TFTP Server allows using UDP 69 port for files transmission. Cisco PIX Firewall) can identify TFTP sessions in data flood and dynamically change the table of addresses translation, allowing TFTP traffic through.
Therefore, even if you configured your firewall to redirect all UDP traffic with the port number equal to 69 to the TFTP server, NAT-device still will not allow TFTP sessions through.Ī number of devices (e.g.
TFTP protocol supposes using random UDP ports to transfer files contents (Look at TFTP protocol part to get more additional information). WinAgents TFTP Server supports transmission of files via TFTP protocol through routers and firewalls, where NAT (Network Address Translation) mode is enabled. WinAgents TFTP Server Configure Server to Work through Firewall or NAT
